#how to find a platinum ring at the beach Tag | The Ring Finders

Handmade 14K Wedding Ring with Diamond Chip Lost While Bodysurfing in Scarborough Maine, With A Metal Detector

  • from Old Orchard Beach (Maine, United States)

On Sunday night 9/3/23, which is also Labor Day Weekend, I received a call from Ric. Ric told me that while Bodysurfing at Scarborough Beach State Park, in Scarborough, Maine, his wedding ring fell off, into the very rough surf water. Ric said he was referred to me by members of the lifeguard crew, including Greg, the supervisor.
As it was already closing in on 4:30pm and the State Park closes at 7:00pm, I told Ric that because I wouldn’t be able to make it from my current location, to the State Park until close to 6:00pm, I would go down 1st thing in the morning and perform a grid search, at low tide. Ric was not going to be available to show me the location of where the ring was lost, but gave me a very detailed description of the location. He was just to the left of the webcam pole and approximately 50-60 feet out into the water, approximately “mid chest deep”.
I arrived at Scarborough Beach State Park the next morning at 8:00am and was greeted by Greg. Greg told me that he didn’t see Ric lose the ring but that it was in the general location described by Ric. I decided to overshoot the area by about 30 feet on each side of the Webcam pole, in case the ring was moved by the rough and strong surf. Starting down near the low tide line, I slowly gridded the hard packed sand, up towards the shoreline. I was finding a few trashy targets, like lobster trap bits and small pieces of aluminum, mostly likely from discarded cans. As I worked my way up towards the shoreline, I finally received a great sounding low tone. Looking down at the CTX-3030’s VDI Screen, I saw a reading that put a smile on my face. I had a great sounding low tone and a 12-19 on the VDI screen. Definitely in the gold range. I pressed my scoop into the sand, with my foot and dumped the sand out next to the hole. I ran the coil over the dug up sand and got the signal. I still couldn’t see it so I pulled my pinpointed out and ran it through the sand. Once I found the target, I put my fingers into the wet dug up sand and pulled out a large chunky ring with a small diamond chip in it. I had Ric’s ring. I called Ric and then sent a photo to him. He replied “That’s it, 100%”. We then made arrangements to meet in 20-30 minutes at a local restaurant, on my way home. The exchange was made and Ric explained that the ring was actually handmade, by a friend, and presented to him for his wedding. As The Ringfinders say, “every ring has a story “ and this one has a very sentimental story. Another great happy ending.

Platinum Wedding Ring Lost On Goose Rocks Beach Kennebunkport, Maine Found With A Metal Detector

  • from Old Orchard Beach (Maine, United States)

At 11:30am on August 11,2023, I received a text that stated a wedding ring had been lost at Goose Rocks Beach, in Kennebunkport, Maine. And then “Are you able to help”? I immediately called back and told him I absolutely could  help. I asked if the ring had been lost in the water or the dry sand? Up on the beach in the dry sand, was his reply. He then told me that she had 3 rings in the pocket of her beach dress and they had fallen out. Two of the rings had been found already, one in the sand and another had landed on a beach chair. However, a wedding ring was still missing and was not found by anyone in the group. I told him that I would leave immediately and be there in 30 minutes +- a few minutes. He texted me the GPS address and my wife and I were off to Kennebunkport. We arrived at the address in about 25 minutes and was met at the address by Chip. Chip explained that the family was still at the beach, which is just down the block and across the street, a 5 minute walk. Once we arrived at on the beach, Chip and Allie (owner of the lost wedding ring, explained how the rings had been lost and where within the 10’ X 15’ area they thought the ring was lost. I fired up the Minelab CTX-3030 and made my first swing.  At the end of the very 1st swing, I received a nice low tone and a 12-05 reading on the CTX-3030. I then asked Allie what type of metal the ring was made of. Platinum was her reply and I told her that this target was promising. I pulled out my pin pointer and located the target. I then moved some sand away with my hand, felt around and pulled out The Platinum Wedding Ring. Allie was very happy and relieved to have her ring back and I also had a big smile that I am still wearing.